|I. Product Information
Product Name: GR-654L
Synonyms: Glass Resin Liquid
Chemical Family: Silicone
Chemical Formula: Mixture
DOT Shipping I.D. Number: UN 1866
DOT Shipping Name: Resin Solution
DOT Hazard Class: 3, Flammable Liquid
EPA Hazardous Waste ID Number: F003
|II. Chemical Components
Listed under Section 313 of Title III (SARA)
Name & Percentage
n-Butyl Alcohol 25-40%
50 ppm (Ceiling)
50 ppm (Ceiling)
250 ppm STEL
STEL = Short term exposure limit.
TLV and PEL are listed as time weighted averages (TWA)
unless otherwise noted.
|III. Physical Properties
Boiling Point: 182 o F
Melting Point: Not Available
Vapor Pressure (mmHg @ 25°C): 71
Solubility in Water: Approximately
Vapor Density (Air = 1): > 1
Specific Gravity: < 1 Percent
Volatile by Volume: 75
Appearance & Odor: Clear liquid
with slight color. Vinous odor.
|IV. Reactivity Data
Incompatible Materials: Strong oxidizing
agents, concentrated mineral acids, hydrofluoric acid.
Hazardous Decomposition Products: Oxides
of carbon, silicon dioxide, water
Hazardous Polymerization: Will not occur.
Conditions to Avoid: Sources of ignition.
Contact or storage with incompatible materials.
|V. Fire And Explosion Data
Flash Point: 73°F
Lower Explosive Limit: 5.3% (Estimate)
Upper Explosive Limit: 34% (Estimate)
Extinguishing Media: Foam, dry chemical,
Special Firefighting Procedures: Wear
pressure demand self-contained breathing apparatus in
conjunction with appropriate personal protective equipment.
Unusual Fire and Explosion Hazards:
This material is a flammable liquid and a dangerous
fire hazard when exposed to heat or flame.
|VI. Health Hazard Information
|Primary Routes of Exposure: Inhalation,
Signs and Symptoms of Overexposure: Depression,
drowsiness, impaired vision, ataxia, stupor.
Medical Conditions Aggravated by Exposure:
Prolonged or repeated exposure may aggravate pre-existing
skin, central nervous system, liver, kidney and/or intestinal
Listing as a Carcinogen: This material
is not listed as a carcinogen by the NTP, IARC, or OSHA.
|VII. Emergency First Aid Procedures
Inhalation: Remove to fresh air.
Seek medical attention.
Ingestion: Consult physician. Gastric
lavage may be necessary.
Eye Contact: Immediately flush eyes
for 15 minutes with large amounts of water, occasionally
lifting upper and lower lids. If irritation persists,
seek medical attention.
Skin Contact: Wash the affected area
with soap and water. Seek medical attention if irritation
|VIII. Control Measures
Engineering Controls: General ventilation
recommended under normal conditions of use.
Work/Hygiene Practices: Avoid inhalation
of vapors. If necessary, wear
NIOSH/MSHA approved respiratory protection for organic
Personal Protective Equipment:
Respiratory Protection: If necessary,
wear NIOSH/MSHA approved respiratory protection for
Eye/Face Protection: Recommended.
Skin Protection: Recommended to prevent
|IX. Storage and Disposal Information
|Handling and Storage Precautions: Store
in a cool, dry location away from oxidizing agents and
combustible materials. Eliminate ignition sources.
Spill or Leak Procedures: Clean up spilled
material into a closed container.
Disposal Methods: Dispose of in accordance
with local, state, or federal regulations.
|X. Manufacturer/Supplier Information
Prepared by: T. L. Richardson
Date: July 1, 1998
Revised: June 16, 2006
24-Hour Emergency Telephone Number:
General Information Number: (419) 873-2120
Manufacturer's Contact: W.J. Blessing
CHEMTREC: (U.S.) (800) 424-9300 (Int’l)